About this paper

Implementation of a static route on an Amer Switch is accomplished by executing the static route command:

Switch(config)#ip route

DestinationNetwork” “Subnet” “NextHopAddress

The command is similar to the Cisco IOS command. The difference lies in the definition of the port in the Amer Switch. In a Cisco network implementation (See Above), in order to allow communication between two subnets connected to independent switches, a static route must be created. The two ports that join Switch0 and Switch1 would be changed to a router port with the execution of the “no switchport” command and  an IP address would then be assigned to the ports.   …[Read More]

How to get this document

Once you fill-in and submit the form, you shall receive an email with the document download link.

Important: Please make sure you provide a valid email address and check your spam folder in case you didn’t get the email after a while.

Download form


First Name (required)

Last Name (required)

Email (required)

Organization/Company

Job Title

Phone Number

Amer Networks News and Offers:
Subscribe

Enter this Captcha :
captcha